# 1
Thule Hitching Post Pro Bike Rack for 4 Bikes - 1-1/4" and 2" Hitches
Super sturdy and easy to use/install. Love the bolt hitch attachment, keeps the rack from swaying/wobbling. Attachment points are very solid and the anti swing clips keep your bikes from smashing into each other and the rack during fast starts and stops. I use for all types of bikes, road, mountain, cruiser, children's, etc.
The good: I like the way the bikes are held in and the ability to add the upright adapters to the bike frame holders. The straps are quality too. For a jeep with a spare tire, this is the perfect length to clear it. This rack is 5 stars from the bike holders to the base of it. The bad: the 2"receiver adapter and bolt are insufficient. I wish they made this in a solid 2" hitch. The entire setup is held into the receiver by a very short bolt. It only goes about half way into the receiver tube. So your hitch is only "secured" on one side. A hitch pin or bolt should go through the receiver tube completely imo so it can be secured on the other end with a retaining clip or nut. Because this only goes in the one side, the entire weight of the rack plus bikes are held tight to one side of the receiver by the undersized bolt and washer. A few bumps down the road and that bolt loosens. Now instead of distibuting the weight of the rack and bikes on the receiver and post, it's completely up to the bolt to keep you from losing the rack. The bolt threads get damaged too. I took this down a dirt road and nearly lost everything. I had to buy my own bolt with hd fender washers and lock washers to correct this. Thule should've provided this from the start. The current short bolt design where only one side of the receiver secures the rack is unacceptable. This rack is 1 star at best for the connection to the receiver.
# 2
Swagman XC2 Bike Rack for 2 bikes - 1-1/4" and 2" Hitches - Frame Mount
I own a 2005 Jeep Wrangler X with 31x10.5x15 oversized tires and wheels. I installed B6196001 HighRock 4x4 Oversize Tire Carrier by Bestop to carry larger spare tire. I needed a bike carrier that would carry our two crusier bikes and clear my spare tire. After measuring, I ordered: -> S64650 - Swagman 2-bike carrier -> 80300 - 7" Hitch Adapter 2" to 1-1/4" Trailer Hitch Receiver -> RM-061 - Roadmaster Quiet Hitch for 2" Trailer Hitches Our order arrived very quickly, etrailer.com upgraded the shipping. All these products arrived well packaged and without damage. In 15 minutes I had every thing assembled, installed on my Jeep and bikes loaded. The bike carrier is very well constructed, finish is excellent and easy to adjust. When adjusting wheel loops and loading bikes, make sure you pay attention to bike pedal position. I chose this extension because I did not want to use the adapter that comes with the bike carrier, I wanted as few parts as possible to keep rattles to a minimum and gives me more options for towing. The anti-rattle bolt/pin firmly secures the bike carrier to the extension and the Roadmaster Quiet Hitch keeps the extension adapter from rattling in the receiver. Road tested approximately 25 miles over rough city roads ( including railroad tracks ), county roads and highway. Bikes traveled very well without any rattles. I can remove my complete setup quickly, fold and put in rear of Jeep if desired. I am very well pleased with my purchase. Note to etrailer: Please consider offering Roadmaster Quiet Hitch in black to match receiver and accessories. Paul In the Land of Oz . . . Just South of the Yellow Brick Road!
It works great! Easy, quick, you know. One needs to screw in the hitch bolt, for some reason, before latching it. Other than that, it makes going bike riding way easier.
# 3
Swagman XTC2 Bike Rack for 2 Bikes - 1-1/4" and 2" Hitches - Frame Mount
First-time rack buyer / owner / installer. The rack arrived in a timely fashion, maybe a day or 2 ahead of schedule. It was well packaged. I’m LOVING this bike rack. It was easy to put together and to mount on my new Honda Passport. Thus far, no squeaks in my 2” receiver. Hardest part of initial set-up is figuring out the best way to position two bikes. Trial & error and some patience. The directions weren’t clear as to where the 2 left-over screws went. I found the answer in another review and have posted a pic in case others have the same problem (photo with pen pointing at screw). These screws go in the underneath side of both of the folding arms. They appear to keep the wheel wells from sliding off in case in you drive with an empty, un-folded rack, and forgot to tighten down the wheel wells. The folding arm push / pull pins can be difficult at times. I coated the tips with some lube. That and a little jiggling seems to solve that issue. I guess it’s better for the pins to be snug vs popping right out. I added a small Master lock to the hitch pin (in lieu of the provided cotter pin) as a theft deterrent. I read that a 3/16 shackle lock will fit into the bike clamp down arms to also act as a deterrent. I had an old 3/16 lock that did snugly fit and appeared to be locked. HOWEVER, I yanked on the lock and it came open as there isn’t quite enough clearance for the shackle to lock. I discovered that longer 3/16 shackle locks are hard to find. Have attached a photo of the lock that actually fits and works (Ace Hardware). One lock on the upper clamp down arm will secure both arms as the lower arm can’t be removed without removing the upper arm. The clamp down arms appear to be coated to prevent damage to your bike. I’ve tried a simple rag and ultimately settled on pool noodle pieces as a precautionary measure. I CAN NOT open my tailgate (regardless of whether or not the rack is fold up and in the bike carry position). If that’s a concern for you, then spring for the more costly titling version. My back-up camera still functions.
The Swagman XTC-2 platform bike carrier arrived very quickly from etrailer and in good shape, the actual carrier box is inside another shipper box, which I'm sure helped with its condition. Assembly was relatively quick and painless, even though the instructions could be a little more thorough. Installing the carrier on the back of our Jeep Patriot also was quick, it helps to have an extra ratchet & 3/4" socket laying around for just this purpose. Installing the bikes takes a little patience and trial and error the first time you try and put them on the carrier. It's easy enough to adjust the wheel holders to fit the wheelbase of your bikes, but for us at least, the challenge was trying to swing the vertical support bar up into position after putting on the first bike (closest to the Jeep). We couldn't angle the bike enough toward the Jeep to have the bar clear the bike. We learned that the easiest way to secure the first bike was to remove the ratcheting frame hooks altogether, put the bike in the carrier, swing up the vertical support bar, put in the pin, and then slide one of the frame hooks down on the bar. The outside bike is much easier because you can set the bike in the carrier at whatever angle you need, not being limited by the back of the vehicle. One thing we did to protect the bike frames was to use some foam pipe insulation as cushion between the frame hook and the frame (see pictures). Once you get a system for installing the bikes, it is very quick to load/unload them. The rack seems to be well made and doesn't wiggle excessively when traveling. All in all a good product for a good price, would definitely recommend it for anyone looking for a platform bike carrier.
# 4
Saris Bones EX 3 Bike Rack - Trunk Mount - Adjustable Arms
Great product so far! Easy to install and adjust. A little tricky to load 2 large handlebar mountain bikes and a third smaller bike, but we just turned them sideways with the front wheels taken off. We had racks on bikes which were probably the impediment. We got them on though! Love how it folds up easy for quick storage. Works great on 2014 Subaru Outback.
Fits great on my Lexus NX but I’m worried about the bottom legs. Instructions doesn’t say if the bottom feet should be on the rear bumper or trunklid. I placed it on the top rear bumper but because of the limited space, the feet is not fully set in. I didn’t place it on the trunklid because I didn’t feel like the trunklid was strong enough to withhold the rack and bikes without possibly making a dent. Also, I searched everywhere but my saris came missing one of the bottom hooks. Had to use side hooks instead because I had to get the huggers for the top and side straps.
# 5
Curt 4 Bike Platform Rack - 2" Hitches - Frame Mount - Tilting
Great bike rack and outstanding customer service. Easy installation, sturdy bike rack and when I encountered a defective support arm, customer service had a replacement part shipped to me in less than one week. Great value and great support. You cannot get better than that.
Besides taking too long to get since being ordered in July, it is a great Curt 4 bike product......Installed it today and it works great. Curt products are made from a strong quality! My Curt hitch was installed over the Summer, ordered from etrailer and it works great also...Very happy of the outcome. Thanks.....
# 6
Hollywood Racks Trail Rider Bike Rack for 2 Bikes - 1-1/4" and 2" Hitches - Frame Mount
I love this bike rack. It was easy to install, has zero problems/issues and my bike was always secure and safe. I did add a cable and lock to act as a theft deterrent while paying for gas, etc. The price is very reasonable compared to others in the market and e-trailers made every step of the purchase and install easy and as simple as one could hope for.
I was impressed with this bike rack from the minute I unpacked it. The assembly was simple & straight forward. I looked at quite a few bike racks & for the price point this product was hard to beat. It is well designed & the keyhole pins make it easy to remove & fold up when not carrying the bikes. The locking hitch pin & locking frame bars are convenient and fairly secure. I will add my cable lock to make the bikes even a little more tamper proof. So far I’m very happy with this his purchase. Now the test of time!
# 7
Thule Passage 3 Bike Carrier - Trunk Mount
The side / bottom straps are seriously lacking. It has those straps you would find on a backpack, making it difficult to securely tighten down because of the angle. I'd usually have to pre-tighten them to a certain length, then forcefully shove the whole rack until it clipped onto my car. They really just need to be ratchet straps. Even then, one of the side straps came off while driving after hitting a small pothole and the whole thing dangled to one side - Luckily I was in a parking lot. I've also never been able to fit 3 regular bikes, only 2. It's really only a capacity of 3 if you have 2-3 slim bikes. The rubber is so wide that it makes it nearly impossible to slide certain bikes on. If you have a step thru bike with one of those crossbar adapters, I wouldn't even bother with trying this. Unfortunately I don't use this anymore since I'd be constantly worrying the whole thing will come off whenever I drive.
Fits perfectly on our Lexus CT200h. Only on the old LS400, the side straps have to be fastened to the wheel arch edge, since the upper trunklid gap is to narrow for inserting the strap hooks. Mounting of two bikes is (with some routine) quickly done, and they stay safe even for longer and faster routes. For transporting three (mountain) bikes, though, the design doesn't seem big and robust enough. Nevertheless, the price-benefit-fun ratios are way better than reasonable.
Swagman Hitch Bike Racks Review - 2012 hyundai veracruz
Today on our 2012 Hyundai Veracruz, we're going to be doing a test fit on the Swagman Dispatch. This is a platform style 2-bike rack. It's been designed for use on 2-inch hitches. Part number on it is S64684. The dispatch rather is an RV approved bike rack. Not only can we use it on our vehicle, we can put that right on the back of our camper or RV.
Thule Hitch Bike Racks Review - 2012 Hyundai Veracruz
Today on our 2012 Hyundai Veracruz we're test fitting the Thule Vertex Swing. This is a swing away style four bike rack been designed for use in two inch hitches. Part number on it is TH9031XT. Now the swing away feature is a pretty straight forward easy operation. We're first going to loosen our black t-bolt. With that out, we'll lift our black pin and start swinging it out from the vehicle.
Thule Hitch Bike Racks Review - 2012 Hyundai Veracruz TH9029XT
Today on our 2012 Hyundai Veracruz, we're test fitting the Thule Vertex. This is a hanging style 4-bike rack designed to fold and tilt. Part number on it is TH9031XT. Now, this works perfectly good whether you're using an 1 1/4 inch hitch or a 2-inch hitch. It's a really nice, versatile rack. Nice thing about it here, you can see the cable lock.
Thule Helium Aero Hitch Bike Racks Review - 2012 Hyundai Veracruz
Today on our 2012 Hyundai Veracruz, we're going to do a test fit on the Thule Helium Aero. This is a folding and tilting 2 bike rack. They've designed it for use with either 1 1/4 or 2 inch hitches. The part number on it is TH9042. Now we also have this in a 3 bike configuration. That part number is TH9043. To begin our test fit, we're going to slide the shank of the rack into the receiver tube of our hitch.
What our customers are saying:
"Everyone that bought before me was right! I got my rack in time for my next days off and putting it together was fast too. And I'm a grandma!! Thank you for being fast and honest! You beat anyone in my town hands down!"